Buffer stack limit exceeded in gxshad

[Diane Stokes]

Michiko,

With that fine a contour interval and the noisiness of the data you are
trying to plot, I think you are asking too much of "gxout shaded".  If
you instead use "gxout grfill", which will fill the entire grid box with
one color (rather than squeeze 10 or 15 colors between two gridpoints),
your script runs successfully with cint=0.05.

If needed, I can try Jennifer's suggestion to double the value of XYBMAX
in gxshad.c when I have time to work on the new builds.

    Diane


Michiko Masutani wrote:
> Diane:
> Thank you very much for responding.
> The directory I am working is in
> /jcsda/save/wx20mm/work/osse/osse_diag/diag2008/dwl.count
> The script I had trouble is
>  tmcoverage.1by1.gs
> It works for cint=1deg  but fails for cint=0.05
> Diane Stokes wrote:
>> Michiko,
>>
>> If you are running on grads on the CCS and want me to take a look:
>>   - direct me to your descriptor file
>>   - tell me what command you ran that resulted in the error
>>
>> Also, in general, it's better if you use the default "Reply-To"
>> address of gradsuser at list.cineca.it so that other folks on the list
>> know if your problem was resolved and how it was resolved.  In this
>> case, it worked out ok.  In this case, I'm not cc'ing the list just
>> yet till I see your data.
>>
>>     Diane
>>
>>
>> Michiko Masutani wrote:
>>> I received error message
>>> Buffer stack limit exceeded in gxshad
>>> Any body know what could cause this error?
>>>
>>> --
>>> Michiko Masutani Ph.D. (Wyle Information Systems)
>>> michiko.masutani at noaa.gov,
>>> Office:Rm 807 Tel. (301)763-8000x7551  Cell: (240)413-6727
>>> NOAA/NWS/NCEP/EMC 5200 Auth Rd. Rm 207 Camp Springs MD 20746
>>> Fax:(301)763-8545
>>> http://www.emc.ncep.noaa.gov/research/JointOSSEs
>>> http://www.emc.ncep.noaa.gov/seminars
>>>
>>
>

--
Diane Stokes
Environmental Modeling Center
National Weather Service/NOAA