[gradsusr] Open 2 CTL files at the same time?

[damu]

Yes,
You can do that, make the script as following. Before looking into the
script, I assume that parameter "u" is in file1.ctl and parameter "v" is in
file2.ctl.

*'open file1.ctl'
open file2.ctl'
'set lat       '
........
'set gxout vector'
'd u.1;v.1'
'close 2';'close 1'*

Good luck

On Sat, Feb 26, 2011 at 10:54 AM, Andrew Revering <andy at f5data.com> wrote:

>  Can you open multiple CTL data files at the same time and manipulate the
> two data sets together?
>
>
>
> I’m running under windows and the only way I could figure out how to create
> the CTL files necessary to read the Grib2 data was a method that requires
> you to create them for each record in the Grib2 data file individually.
>
>
>
> So now I want to use a couple variables (like ugrd and vgrd) to do a vector
> plot, but the two variables are in two separate ctl files.
>
>
>
> _______________________________________________
> gradsusr mailing list
> gradsusr at gradsusr.org
> http://gradsusr.org/mailman/listinfo/gradsusr
>
>


-- 
damodararao valavala
damodararaov at yahoo.co.in, drao at .nio.org
Biogeochemisrty and Environmental Research Lab,
National Institute of Oceanography,
Regional Centre, Waltair,
176, Lawsons Bay colony,
Visakhapatnam-530 017
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://gradsusr.org/pipermail/gradsusr/attachments/20110226/76a50749/attachment-0003.html