cbarn.gs

[Sestak, Michael L CIV 63134]

After your last plot, but before you change the vpage, put

'q shades'
_shades=result


From: Esther Romero Olivares
Sent: Thu 10/22/2009 5:23
To: GRADSUSR at LIST.CINECA.IT
Subject: Re: cbarn.gs


Thanks!

But if I have used the "set vpage" command it will plot the legend
inside the virtual page defined, even if I don't specified any
parameter.

If I use after the plot "set vpage off" to return to the default state
where the real page equals the virtual one it says that does not have
any shading information.

I would like to have many plots but just one legend in the bottom of the
page...

Thanks again!

Esther.

El jue, 22-10-2009 a las 14:11, eliav schmulewitz escribió:
> Esther
> sure you can
> if you open the cbarn script that is in the same file as your grads
> probably in a file called scripts
> it explains as folows:
> "run cbarn sf vert xmid ymid
> *
> *    sf   - scale the whole bar 1.0 = original 0.5 half the size, etc.
> *    vert - 0 FORCES a horizontal bar = 1 a vertical bar
> *    xmid - the x position on the virtual page the center the bar
> *    ymid - the x position on the virtual page the center the bar
> *
> *    if vert,xmid,ymid are not specified, they are selected
> *    as in the original algorithm"
> good luck
> eliav
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://gradsusr.org/pipermail/gradsusr/attachments/20091022/60c012f3/attachment.html