[gradsusr] plot WRF output PBL height v/s time

[Jayakrishnan P.R]

Suppose your data file is pbl.nc. You need to plot the pbl at the point say
10 N, 75 E and from 1may2010 to 31oct 2010,
then
'sdfopen pbl.nc'
'set lat 10'
'set lon 75'
'set time 1may2010 31oct2010'
'd pbl'


This may do the job.



Sincerely
***********************************************
Dr. Jayakrishnan.P.R
Project Scientist-C
National Centre for Medium Range Weather Forecasting
Earth System Science Organisation
Ministry of Earth Sciences
A-50, Sector 62, NOIDA -201 309, INDIA
Mob: 09496026547
Alternate Email: jkrishna at ncmrwf.gov.in

***********************************************

On Mon, Jun 22, 2015 at 11:15 PM, Jeff Duda <jeffduda319 at gmail.com> wrote:

> Ashish,
> I don't understand what the difficulty is. Displaying a field in GrADS is
> as simple as typing 'd field' at the command prompt after opening the data
> file. What kinds of suggestions are you looking for?
>
> Jeff Duda
>
> On Mon, Jun 22, 2015 at 10:07 AM, Ashish Sharma <asharma7 at nd.edu> wrote:
>
>> Hello,
>>
>> I need to plot WRF output PBL height v/s time at a specific grid point.
>> Any suggestion  would help.
>>
>> thanks,
>> Ashish
>> _______________________________________________
>> gradsusr mailing list
>> gradsusr at gradsusr.org
>> http://gradsusr.org/mailman/listinfo/gradsusr
>>
>
>
>
> --
> Jeff Duda
> Graduate research assistant
> University of Oklahoma School of Meteorology
> Center for Analysis and Prediction of Storms
>
> _______________________________________________
> gradsusr mailing list
> gradsusr at gradsusr.org
> http://gradsusr.org/mailman/listinfo/gradsusr
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://gradsusr.org/pipermail/gradsusr/attachments/20150623/0095b94c/attachment.html