[gradsusr] how to make descriptor file

[Mario Caffera]

I think the file is a little corrupt. I suggest to download or construct the file again.
  mario

________________________________
 From: wendi harjupa <wendiharjupa at gmail.com>
To: GrADS Users Forum <gradsusr at gradsusr.org> 
Sent: Sunday, April 7, 2013 3:17 AM
Subject: [gradsusr] how to make descriptor file
 

Dear Sir/Madam

I need help
I have NetCDF data (wind data)
I tried to open it with command "sdfopen"
but I could not see the contain of data. 
I got message as follows :
"Scanning self-describing file:  20040410.nc
gadsdf: SDF file has no discernable X coordinate.
  To open this file with GrADS, use a descriptor file with an XDEF entry.
  Documentation is at http://iges.org/grads/gadoc/SDFdescriptorfile.html"

How to make the descriptor file, while we do not the contain of data.

I attached the data as well in this email.

Thank you very much for your help

Best regards,
wendi


-- 
-------------
Wendi Harjupa. ST                                            
Shimane University Graduate School of Engineering Sciences
Department of Electronic Control Systems
Remote Sensing Laboratory
s119447
Cellphone : +81-080-4268-6676
email : wendi at rslab.riko.shimane-u.ac.jp
_______________________________________________
gradsusr mailing list
gradsusr at gradsusr.org
http://gradsusr.org/mailman/listinfo/gradsusr
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://gradsusr.org/pipermail/gradsusr/attachments/20130407/a4318915/attachment-0003.html