[gradsusr] Time Stamp

[MY]

Hi, Andrew,

You'd better draw them by "draw string". The time information can be obtained by
--------
'q time'      ;*  returns:  Time = 00z01jul2010 to 00z01jul2010 Thu to Thu
timstr=subwrd(result, 3)
--------

you can then draw the string by
--------
'draw string 'x' 'y' 'timestr
--------
where the x and y are the location in virtual page. Please note there
is a blank between the quotation marks.

Good luck!

MY

2010/7/10 Andrew Revering <andy at f5data.com>:
> This may be a stupid question… but I can't seem to figure out how to put the
> actual model run time stamp on the Grads image.
>
> I know you can do the time that the image was made, but how do I pull either
> the valid time of the forecast, and/or the model run (initialization) time
> and plot it on the image?
>
>
>
>
>
> Andrew Revering
>
> Convective Development, Inc.
>
> http://www.convectivedevelopment.com/
>
>
>
>
>
> _______________________________________________
> gradsusr mailing list
> gradsusr at gradsusr.org
> http://gradsusr.org/mailman/listinfo/gradsusr
>
>



-- 
++++++++++++++++++++++++++++++++++++++++++++++++++++
YING, Ming
Shanghai Typhoon Institute of China Meteorological Administration
166 Puxi Road, Xuhui District, Shanghai, 200030
PR China
++++++++++++++++++++++++++++++++++++++++++++++++++++